Installation: Pattern

Important note: If you ordered luxury paper prior to April 1st 2026, you are required to thoroughly wet the back of the paper with water and allow it to rest for 5 minutes before hanging it on the wall. This step only applies to luxury paper.

If you ordered luxury paper from April 1st 2026 onward, this additional step is not required.

If you experience any issues or have any product concerns while installing your wallpaper then please email hello@bobbibeck.com with photos at the earliest possible chance. We recommend that you stop installing the wallpaper if there are issues.

Tools you will need;

• Ready-mixed paste
• Paint brush
• Sharp knife
• Sponge
• Spirit level
• Wallpaper smoother

Step 1. Wall preparation

Walls should be smooth, clean, dry and a uniform colour before hanging wallpaper. Fill and sand any holes, cracks or imperfections, and remove any dust, grease, loose paint or old adhesive. Textured walls should be skimmed smooth or lined with suitable lining paper. New plaster and other absorbent surfaces should be sealed with a wallpaper primer before installation.

Step 2. Measure & cut your drops

Measure the height of your wall, then mark the measurements on the back of the wallpaper. Cut your first drop, allowing an extra 100 mm (4 in) at the top and bottom for trimming. Refer to online product page for the match type and pattern repeat before cutting additional drops. When measuring subsequent lengths, allow for pattern matching and cut each drop in sequence.

Step 3. Paste the wall & begin hanging

Use a brush to apply adhesive to the wall and cut in around edges, corners and fixtures. Once the wall is pasted, begin hanging the wallpaper from the top down. For the most accurate installation, measure the wallpaper width and lightly mark it on the wall with a pencil. Using a spirit level, draw a vertical guideline from ceiling to floor and align the first drop to this line.

Paste one drop-width at a time to prevent the adhesive from drying before hanging. As you hang the wallpaper, smooth away any ripples or air bubbles using a smoother. Once the drop is positioned correctly, trim the excess wallpaper at the ceiling and skirting board using a sharp blade before the paste fully dries.

Step 4. Continue hanging

When hanging subsequent drops, carefully match the pattern and butt the edges together without overlapping. Press the seams firmly to create a neat finish. Take care to avoid getting adhesive on the face of the wallpaper. If any paste comes into contact with the surface, gently remove it with a damp sponge.

Once installed, allow the wallpaper to dry at room temperature for at least 24 hours. Avoid significant changes in temperature or humidity during this time.